Anyone done an install on copper pipe?

No worries @emil . His shop ended up ordering the wrong parts for him, so I’m waiting to hear back from him on a new install date.

Why do you need a plumber if you’re using the SharkBite fittings? Those are expensive so that you can DIY. If you’re paying for a plumber then have him sweat everything on with copper couplings - much cheaper.

[image] nmstough: If you’re paying for a plumber then have him sweat everything on with copper couplings - much cheaper. Would I still be able to rotate the unit and would I be able to replace it on my own later? I’m just looking for him to do this install, then I could make a swap later if …

@nmstough - I’m not sure the flow meter has copper ends, plus with parts of the flow meter being non-metallic I wouldn’t want the heat from sweating to melt the non-metallic parts if the heat from sweating traveling down the pipe. Additionally, Rachio doesn’t recommend any solvent or glue as that c…

[image] DLane: I’m not sure the flow meter has copper ends They’re not copper. Thanks for the input @DLane . I do quite a bit of DIY stuff around the house but I get intimidated when it comes to copper pipes, thus the plumber. :wink:

By the way, why does one need to rotate the unit to change the batteries? Why not install it with the battery cover facing outward to begin with?

@nmstough - my unit will be underground and I think that would put the transmitter farther underground with more signal attenuation. Plus there is the green light on top that one may need to look at for connectivity or issues. In the above installation, it could probably be positioned where both s…

Emil did come out and fix my error. All is working fine now, and will post picture shortly. A massive thanks to Rachio and Emil for great customer support, service and working directly with a customer in the field. We had a great discussion / chat as I am a techy geek as well working for over 30 yea…

Attached is a final picture of my 3/4 main feed and attaching the flow meter to 3/4’’ copper with 1’ Copper either side. All works great so far. [Rachio_Flow_Meter_June2018]

That’s one beautiful install @knighti10 and @emil !

Home | Support | Status Page

Rachio Community

Copper pipe flow meter install

Getting Started Wireless Flow Meter