Smart cycle: zone specific?

[Xiecix]

Hello,

I would like Rachio to determine how ‘cycle and soak’ is done - for all but ‘one zone’…

For the ‘one zone’, it takes as much as 10 minutes to pop all heads due to line pressure. Yes, I need to address that. But for now, I’d like to prevent for that zone.

Is there a way to designate?

[franz]

@Xiecix

But for now, I’d like to prevent for that zone.

Is there a way to designate?

A workaround is to make the nozzle type one of drip types. Drip nozzle zones are not included into cycle/soak. Just make sure you capture your current nozzle precip rate and set it back to that value before you change the nozzle type.

[Xiecix]

Sweet! Done