First i want to say, I love Rachio, it is the only controller i install and I am currently shared into over 200 wonderful rachio controllers.
My question today is, How can i get the unsightly “zone fault” warning off of a controller that is using an add-a-zone or other single field wire type device.
Thanks!
Just for further clarification: Everything is working as expected are far as operation goes, its just, I can sort of see the look on my customer’s face when i tell them not to worry about the “zone fault” label that i think i can most accurately describe as “not 101% convinced”.
It would just be nice to be able to remove this “Zone fault” label when we know its a special wire sharing device that reads as “Open” on an electrical resistance test.
Much love, Rhett