@Varmalx, do you know if your system is activated at the backflow? If it was winterized, you might have to open the backflow valves to allow water to the zones for the sprinklers to run. I checked your account and your master valve is enabled and controller is reporting manual runs properly, so we either have an electrical issue in the wiring (i.e. power isn’t getting the solenoids), or water issue.
Some ideas for further troubleshooting:
- Double check the connection between the front cover and wall mount on your controller – sometimes the front cover (which sends power to the valves) can become loose over the winter; simply pull it off and reattach it for a secure fit.
- Check your backflow – make sure the valves are aligned like the blue handles in the photo on this support article.
- Manually open a valve – look for a valve box (usually a green lid in in your lawn; photo in the above support article). Open it and twist the bleed screw or solenoid on one of the zones. Here’s a 3rd party video that shows how.
Let us know if this helps/works!