Hello, Is this a bug with the Rachio 3? I recently switched from the Rain Bird controllers to R3’s and I am getting these? [Screenshot_20181011-170239]

@though is right, your sensor should be connected to S1 and 24V- [image] How do I install a wired sensor or wired flow meter with Rachio 3? Quick Overview Wired Flow Sensors While we recommend using the Rachio Wireless Flow Meter to complete your Rachio 3 Smart Water System, the Rachio 3 …

it’s NOT the Rain Sensor because it’s brand new NOR is it wiring because it was just professionally installed correctly… too many threads all over the internet about this issue…

take a pic of the wiring and attach it.

sounds to me like it was installed incorrectly. we’ll see when we see the photos.

Sent reply with picture of wiring… let me know if you got it and it shows what you needed…

It doesn’t show that you posted a photo.

That worked BUT 3 of your 4 wires are covered up by the wire nuts. Pull the wire nuts back and retake the pic so we can see where all 4 colored wires are going.

It appears wired correctly looking at your photo. Is S1 turned on in your app and set to “Rain sensor”? and S2 is off? Are you still getting multiple false duplicates?

Yes S1is turned on in the app and S2 is turned off… it has rained twice since install date… 1st time got multiple false duplicates like you showed on your post a year ago… 2nd time got one… hasn’t rained in the last few days

Home | Support | Status Page

Rachio Community

Continuous Sensor Activated/Deactivated?

Accessories & Sensors Rain Sensors

MarcusDFW September 2, 2019, 10:09pm 63