I’m not sure what’s going on here.
I did find the directions originally taped to the Orbit controller:
This is the valve in reference:
It’s turned on and the sprinkler hose attached to it is functional.
Also keep in mind the relay, compressor etc. where hooked up to the system with these directions attached.
The compressor looks to be attached in line as the pipes from the irrigation control to directly to it:
My assumption is that the piping goes under the shed to reach the irrigation control?
The manual override looks like it has a coarse and fine adjust. They appeared to be turned left already, or at least the coarse adjust.
I can’t get water out of any sprinkler heads after fiddling with them a while.
However the ground in the irrigation control box did get a bit wet.
I feel even more stumped than in the beginning.
I suppose it’s not possible to use a hose in an attempt to get water into the system?
Is there a broken pipe perhaps?
I don’t know what to think at this point.